The cost includes the installation of a new 3-Ton Carrier Performance 27TPA8 Series, 15.2-SEER2, Two-Stage, Dual Fuel Heat Pump & Gas Heating System as follows:
Install new indoor furnace and evaporator coil as follows:
• Remove and dispose of the existing indoor furnace
• Install a new indoor 15.2-Seer2 two-stage 58TP0B070V17–16 gas furnace
• Install a new evaporator coil and connect to furnace
• Install a new drain pan if needed
• Blow out the existing drain line and reconnect
• Ensure the new system is level and secure
• Transition the supply side and return air side plenums to the furnace
• Apply an airtight seal to the plenums and furnace
• Install new safety switches
• Install a new Ecobee Wi-Fi thermostat with Intelisense
Install new outdoor condenser as follows
• Remove and dispose of the existing outdoor AC unit
• Install a new two-stage 27TPA836A003 heat pump 15.2-Seer2 outdoor AC unit
• Replace the existing condenser pad if needed
• Replace the existing electrical disconnect
• Acid-flushed the existing line set to remove contaminants and reconnect
• Install a new drier filter to protect against potential future contaminants
• Install locking caps on the Freon valves to eliminate tampering
• Commission the system and calibrate to the manufacturer’s specs
Includes
• Run heat load calculations pre-install to verify proper sizing
• Register the new equipment in the owner’s name to protect the factory parts warranty
• Perform city permitting and city inspection if required
• Start rebate paperwork for the homeowner to finalize and turn in to the utility company
Labor Warranty
10-Year Carrier Factory warranty on parts
2-Year warranty on labor
Addition 5 & 10-year labor warranties at additional cost
